Vibro-isolation Turbo M4 (70 sm x 50 sm)

Description vibro-isolation Turbo M4 (70 sm x 50 sm)

High-quality vibration isolation in the vehicle

The Turbo M4 Vibration Isolator (70 cmx50 cm) is a vibration-absorbing material and is used in places of heavy vibration. Differs in high-quality performance and high-performance indicators.

Material features

Vibration isolation is used in different places in the car, performing its functions at the highest level:

1. To insulate the floor in a vehicle – thanks to vibration isolation, it is possible to protect the paint layer from dirt and dust, sometimes condensation, which can lead to corrosion. As a result, the skeleton improves and the «flex» is absorbed, noise from the road surface, exhaust system, engine is removed.

2. For car arches – in this case, the noise level from the road surface, suspension, car wheels, as well as from stones and other particles that get into car arches is reduced. The result is the provision of silence and comfort in the vehicle interior.

3. Sounds and noise from the exhaust pipe and rear wheels, muffler is muffled in the trunk on the floor. In addition, this protects the paint layer from dirt and dust, condensation and other influences that can cause corrosion.

Installation

Vibration isolation has an excellent adhesive layer, which is additionally protected by an anti-adhesive coating, it must be removed immediately before use. For easier cutting, the foil surface is embossed with cells, its dimensions are 5x5mm.

Installation features:

1. When cutting vibration isolation gloves should be used to avoid cuts on the edges of the foil covering.

2. To carry out better work on vibration isolation, work must be performed at a temperature of 15-25 degrees. In cold weather, it is recommended to use a special mounting hair dryer, first heating the application site.

3. Install materials for vibration isolation on a clean and grease-free surface. For this, special products are used that do not contain wax.

4. After application, the piece of insulation must be rolled with a roller or other similar device, it is important not to leave air bubbles.

It is recommended to install vibration isolation joint to joint or with a slight offset. In the case of overlapping sheet installation, then the place of overlapping of two cuts must be rolled well.

Vibration isolation: Best Sellers