Intelligent charger EMOS EE04A

Description intelligent charger EMOS EE04A

EMOS EE04A 6/12V, 4A Intelligent Universal 7-Step Charger Features Good Performance, Stable Performance and Reliability. This model is suitable for working with a wide variety of rechargeable batteries: cars, motorcycles, ATVs, vans, boats, jet skis, as well as backup power sources. It can be used for batteries of various designs: lead-acid, AGM and GEL.

Thanks to the built-in processor, charge control is carried out; when connected, the device automatically conducts battery diagnostics and determines the optimal charge parameters. There is also a recovery function for easily sulfated batteries. LED indication of the charging process. The end of charging occurs automatically and the device goes into maintenance mode. For mounting and convenience, the housing has 4 special holes.

Maximum charge current 4 A

The device is capable of delivering a charging current of up to 4 Amperes. This will be enough to work with most batteries.

Charges 12V batteries

The device is suitable for use with car batteries with a working voltage of 12 volts.

Moisture protection

The device is made in a reliable plastic case, which is well protected from dust and water, meets the requirements of IP65.

7 charge modes

The device has ample opportunities for recharging and restoring starter batteries, 7 charge levels are available.

Charges 6V batteries

The device is suitable for use with motorcycle batteries with an operating voltage of 6 Volts.

Works with different batteries

This is a universal charger with several charging modes for small and large batteries with capacities from 1.2 Ah to 120 Ah.

Works at any temperature

This device is capable of charging car batteries in cold conditions. It is not afraid of frost and works stably.

High level of protection

The device has an automatic protection system against short circuit, overheating, overload, reverse polarity. In the event of an emergency, a special indicator turns on and the charger automatically turns off.

7 charge modes:

Step 1-Diagnostics: The charger will diagnose the connected battery (detects an electrical voltage). Detects battery status.

Step 2 Recovery. If the high voltage of the discharged battery is greater than 7.5 V, the charger will start charging with small current pulses so that the connected battery recovers. After the voltage reaches 10.5 V, the device goes into charging mode I. If the battery voltage is higher than 10.5 V, the charger will stop the recovery process and switch to charging mode I.

Step 3 Charge I: Charge the maximum possible current of 4 A, approximately 80% of the battery capacity. Until the voltage reaches the value of 12.8 V.

Step 4 Charge II: Charge with a lower current of 3 A until the battery voltage reaches 14.1 V.

Step 5 -: Absorption: Charging with a low current of 0.8 A to increase the voltage from 14.1 V to 14.4 V (14.7 V in cold weather). In this phase, almost 100% of the battery is being charged.

Step 6 -: Recharging I: Keeps the battery voltage at maximum by ensuring continuous charging voltage.

Step 7 -: Charging II: Support the battery at 95-100% of its capacity. The charger monitors the battery voltage and, if necessary, gives an impetus to keep the battery fully charged.

What's in the box:

— charging cable (red and black) 1.8 m;

— clips (crocodiles);

— charger;

— 1.2 m network cable with a network plug;

— operation manual.

Starter-chargers: Best Sellers